Thursday, 18 August 2016
3D Printing PLA Not Sticking
I have found that using blue masking tape works for helping adhesion of PLA on heated build plate. Though the brand I bought was not very good in that the print wouldn't stick to the plate. 3M blue masking tape is apparently the best for this. While I waited for this tape to arrive I used hairspray sprayed onto the glass build plate , this provided good adhesion for my prints. I like the idea of the blue tape as it's less messy than the hairspray method.
Subscribe to:
Post Comments (Atom)
Defender 300tdi Lucas 10AS Alarm Immobiliser (Spider) Problems
We have a 1997 Landrover Defender 300tdi that has given immobiliser problems intermittently. I had initially fixed the fuel solenoid as we w...
-
Server failure This server failed with the error "E171F PCIE Fatal Err B0 D3 F0" during power up. Upon inspection it was found th... -
I bricked my MR3220 router with an OpenWRT firmware upload. I did manage to get it back by soldering a 4 pin header on its pcb to allow conn... -
I make no guarantees for the information contained herein, I also cannot be held responsible for data loss as a result of your actions, we m...
I'm using plain cheap painters tape from hardware store. If they won't stick, I wash them with isopropil alcohol.
ReplyDeleteThe first layer must go hot, low and fat.