Setup Serial Port
I use Ubuntu 12.04 LTS 64bit and install apcupsd using the command:-
sudo apt-get install apcupsd
I edited the file /etc/default/apcupsd and changed the entry
ISCONFIGURED=NO to ISCONFIGURED=YES
I found out the USB dongle serial port used by issuing the command dmesg | grep ttyUSB in my case it was /dev/ttyUSB2. This was added to the config file /etc/apcupsd/apcupsd.conf file
DEVICE /dev/ttyUSB2
UPSTYPE apcsmart
I then issued the command sudo apctest this allowed me to run a battery calibration test.
Subscribe to:
Post Comments (Atom)
Defender 300tdi Lucas 10AS Alarm Immobiliser (Spider) Problems
We have a 1997 Landrover Defender 300tdi that has given immobiliser problems intermittently. I had initially fixed the fuel solenoid as we w...
-
Server failure This server failed with the error "E171F PCIE Fatal Err B0 D3 F0" during power up. Upon inspection it was found th... -
I bricked my MR3220 router with an OpenWRT firmware upload. I did manage to get it back by soldering a 4 pin header on its pcb to allow conn... -
I make no guarantees for the information contained herein, I also cannot be held responsible for data loss as a result of your actions, we m...
No comments:
Post a Comment