I needed to and Aliases for some IP addresses to the ethernet card on the Rocks Cluster to allow individual nodes to have their own public IP addresses.
I created a copy of the /etc/sysconfig/network-scripts/ifcfg-eth0 to ifcfg-eth0:0. This new file was edited with vi to contain
DEVICE=eth0:0
HWADDR=xx:xx:xx:xx:xx:xx
IPADDR=xxx.xxx.xxx.xx
NETMASK=255.255.255.0
BOOTPROTO=static
ONBOOT=yes
/sbin/service network restart to update the changes made.
/sbin/ifconfig shows the new configuration.
The change was tested by connecting the node switch to the public 211 subnet and the ip address could be pinged from the subnet showing that the changes were working.
Info On Binding IP Addresses
A place to where I can record my Technical stuff that should be accessible from anywhere. It is mainly technical stuff I find interesting and I suppose it can be looked on as a modern Lab-book.
Wednesday, 25 August 2010
Subscribe to:
Post Comments (Atom)
Defender 300tdi Lucas 10AS Alarm Immobiliser (Spider) Problems
We have a 1997 Landrover Defender 300tdi that has given immobiliser problems intermittently. I had initially fixed the fuel solenoid as we w...
-
Server failure This server failed with the error "E171F PCIE Fatal Err B0 D3 F0" during power up. Upon inspection it was found th...
-
I bricked my MR3220 router with an OpenWRT firmware upload. I did manage to get it back by soldering a 4 pin header on its pcb to allow conn...
-
I make no guarantees for the information contained herein, I also cannot be held responsible for data loss as a result of your actions, we m...
No comments:
Post a Comment